It has been built for a Duratec 2.5L so you will see in the pictures it has the Duratec bell housing fitted, however it can be sold without this if needed for a different engine.

Clutch shaft is 1''x23 spline - please contact for full measurements

Please see below full details:

ST82-14 Gearbox with oil pump - 14/34, 19/34, 23/32, 24/28, 24/24, 23/20, final drive 12x58

Slave cylinder 54mm / 12mm spacer

Ramp angles 35/60-(35/90) 120Nm preload

Reverse release cable 1500mm

Additional accessories if required:

x2 Tripod kits complete with rubber boot & fittings

x1 Duratec bell housing

x1 SADEV gear lever